Leica MZ16 A User Manual page 5

Components
Connections
without motor focus
Connections
with motor focus
13 12 11
Connection to PC
1 Stand (transmitted light or incident light with suitable
illumination)
2 Optics carrier Leica MZ16 A
3 ErgoTubus™
4 Wide-field eyepieces for spectacle wearers
5 Objective nosepiece with 2 objectives
(or an interchangeable objective, see the figure on page 5)
6 Motor focus system
(or manual coarse/fine drive, see the figure on page 5)
7 Manual control for motor zoom with connector
for motor focus manual control
8 Manual control for motor focus
9 Transformer (not illustrated)
For assembly and installation of the Leica MZ16 A refer to the
user manual for Leica M stereomicroscopes, M2-105-0
Power supply required.
10 PWR: power supply connection
11 CTL1: Connection for motor zoom foot switch
and/or PC interface kit (with Y-cable)
12 CTL2: Connection for motor zoom manual control or empty
13 CTL2: Connection for motor zoom manual control or empty
Supply through power supply of motor focus, no other power
supply is required.
10 PWR: empty
10
14 CTL1: Connection for motor zoom foot switch and/or PC
interface kit (with Y-cable)
12 CTL2: Connection for motor zoom manual control or empty
13 CTL2: Connection for short connecting cable to motor focus
14 Short connection for motor zoom manual control:
motor focus manual control
For equipment with motor focus, is imperative that the
cable holder is affixed (glued) onto the motor focus and
the short connecting cable from the manual control of the
motor zoom is clamped underneath it. Otherwise the
cable could be squeezed between stop and motor focus
during focusing.
The connection to a PC requires a standard PC with RS-232
interface and a Leica PC interface kit. The individual functions
and commands are described in a separate user manual
supplied with the PC interface kit.
Leica MZ16 A – Overviews 5