Roland GR-33 Owner's Manual page 70

I
Chapter 6 Using the Built-in Effects
32: EH
-+
CHO (Enhancer
-+
Chorus)
This effect connects an enhancer and a chorus in series.
Lin
Rin
EH SENS {Enhancer sensitivity) 0-127
Specify the sensitivity of the enhancer.
EH MIX {Enhancer mix level) 0-127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
CHO PRE DLY (Chorus pre delay time)
0.0-100 ms
Specify the time delay from the original sound until the
chorus sound is heard.
CHO RATE {Chorus rate) 0.05-10.0 Hz#
Specify the modulation frequency of the chorus sound.
CHO DEPTH (Chorus depth) 0-127
Specify the modulation depth of the chorus sound.
CHO BALANCE (Chorus balance)
D 100:0E-DO: 1 00E
Specify the volume balance between the enhancer sound that
docs not pass through the chorus and the enhancer sound
that does pass through the chorus.
A setting of D100:0E will output only the enhancer sow1d,
and a setting of D0:lO0E will output only the enhancer sound
that is passed through the chorus.
LEVEL {Output level) 0-127
Specify the output volume.
70
33: EH
-+
FL (Enhancer
-+
Flanger)
This effect connects an enhancer and a flanger in series.
Lin
R in
EH SENS (Enhancer sensitivity) 0-127
Specify the sensitivity of the enl1ancer.
EH MIX (Enhancer mix level) 0-127
Specify the volume of the overtones generated by the
enhancer, relative to the original sound.
FL PRE DLY (Flanger pre delay time)
0.0-100 ms
Specify the time delay from the original sound until the
Hanger sound is heard.
FL RATE {Flanger rate) 0.05-10.0 Hz#
Specify the modulation frequency of the flanger sound.
FL DEPTH {Flanger depth) 0-127
Specify the modulation depth of the flangcr sound.
FL FEEDBACK (Flanger feedback level) ·98-+98 %
Specify the proportion
('1/u)
of the flanger sound which will be
returned to the input.
Positive(+) settings will return the sound to the input with
the original phase, while negative(-) settings produce an
inverted phase. ·
You can set a value from -98% to +98%, in steps of 2%. There
is no feedback when the value is zero.
FL BALANCE (Flanger balance)
D 100:0E-DO: 1 00E
Specify the volume balance between the enhancer sound that
does not pass through the flanger and the enhancer sound
that does pass through the flanger.
A setting of D100:0E will output only the enhancer sound,
and a setting of D0:lO0E will output only the enhancer sound
that is passed through the flanger.
LEVEL (Output level) 0-127
Specify the output volume.