Table of Contents
Advertisement
I
Chapter 6 Using the Built-in Effects
13: SPACE-D
Space-0 is a multiple chorus that applies two-stage
modulation in stereo. It does not produce a sense of
modulation, but creates a transparent chorus effect.
Lout
Rout
PRE DELAY (Pre delay time) 0.0-100 ms
Specify the delay time from the original sound until the
chorus sound is heard.
RATE 0.05-10.0 Hz#
Specify the modulation frequency of the chorus sound.
DEPTH 0-127
Specify the modulation depth of the chorus sound.
PHASE 0-180
Specify the spaciousness of the chorus sound.
LOW GAIN ·15-+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive(+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN • 1 5-+ 1 S dB
Specify the gain (amow1t of boost or cut) for the high
frequency range.
Positive(+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E-D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of 0100:0E only the original sound will be
output, and with a setting of 00:lOOE only the chorus sound
will be output.
LEVEL (Output level) 0-127
Specify the output volume.
14: STEREO-CHO {Stereo Chorus)
This is a stereo chorus. A filter allows you to adjust the tone
of the chorus sound.
Lout
Rout
60
FILTER TYPE Off/LPF/HPF
Select the type of filter
Off:
A filter will not be used.
LPF:
The frequency region above the Cutoff Freq setting will
be cut.
HPF:
The frequency region below the Cutoff Freq setting will
be cut.
CUTOFF FREQ (Cutoff frequency)
200/250/315/400/500/630/800/1000/1250/1600/2000/2500/3150/
4000/5000/6300/8000 (200-8000 Hz)
Specify the frequency at which the filter will begin cutting.
PRE DELAY (Pre delay time) 0.0-100 ms
Specify the time delay from the original sound until the
d10rus sound is heard.
RATE 0.05-10.0 Hz#
Specify the modulation frequency of the chorus sound.
DEPTH 0-127
Specify the modulation depth of the chorus sound.
PHASE 0-180
Specify the spaciousness of the chorus sound.
LOW GAIN ·15-+15 dB
Specify the gain (amount of boost or cut) for the low
frequency range.
Positive (+)settings will emphasize (boost) the low
frequency range.
HIGH GAIN • 1 5-+ 15 dB
Specify the gain (amount of boost or cut) for the high
frequency range.
Positive(+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E-D0:100E
Specify the volume balance between the original sound and
the chorus sound.
With a setting of 0100:0E only the original sound will be
output, and with a setting of 00:lOOE only the chorus sound
will be output.
LEVEL (Output level) 0-127
Specify the output volume.
Advertisement
Table of Contents
