Table of Contents
Advertisement
Chapter 2 Selecting and Playing Sounds (Patches)
* Sollletimes wizen pressing and releasing the foot switch to
switch banks, you may find that wlzile the bank docs clzange,
1/ze patc/z 1111111ber 11111_11 not (iig/zt will.flash); lwweuer, t/zis does
not indicate any malfunctio11. You can also make the setting
with the FS-SU polarity switch, as slzown in the figure below.
0
mo
Polarity switch
*
If the "S1/52 FUNCTION" /Ills been set to "Patch Select," the
action of the foot switch just described changes to switching
patches up and down (p.
21).
Selecting Patches with an
External MIDI Foot Controller
While the base module's four pedals are being used as
designated pedals (p. 26) for such effects as hold and wah,
you may also wish to switch patches using your foot.
In such cases, you should hook up an external MIDI foot
controller (e.g. FC-200, Boss FC-50, and so on).
Make the settings, using the following procedure.
1. Connect equipment as shown in the figure below.
UIDIOUT
!
!31.aOSSFC·SOMIOIAIIITCONRDLLEII
Im"'
~~~~~~
MIDI Foot Controller
lJ1JU
2.
Press [SYSTEM) to enter System mode.
The patch number dL~play corresponds tn the display on
the MIDI foot controller, but with numbers 001 to 256
instead of the alphanumeric symbols in patch numbers
used by the GR-33.
3.
Press [PARAMETER] to select "DISPLAY TYPE."
24
DI SPLA'-,-' T'-.-'PE
GrF-/Bnk .-··liW•J
4. Use [VALUE] to select "Decimal."
• Decimal:
Patch numbers will be displayed as a decimal number in
the range of 001-256.
• Grp/Bnk/Num:
Patch numbers will be displayed as a group/bank/
number from A11-H84.
5. Press [PARAMETER] to select "Sl/S2 FUNCTION."
6. Use [VALUE] to select "Patch Select."
~
For details, refer to "Selecting a Patch/Using the Guitar
(GK-
2A) to Select Patches."
7.
Press [PLAY] to return to Play mode.
The patch number displayed will be "001," rather than
"All."
8. Set the MIDI send channel of the MIDI foot controller
to match the channel of the GR-33 (p.
86;
the factory
setting is channel Mono 11).
9. Use the MIDI foot controller to switch patches
externally, operating the controller according to the
instructions in the owner's manual.
*
The patch number using the 1111111eml-only format that was set
in step 4 is stored in 111e111on1 ePe11 after the power is fumed
vfl
If necessa,-y,
rct11rn
the patch number display to tire
Gro11p/bank/11umber format.
Additionally, user patches (001 to 128, or All to D84)
can usually be selected when MIDI program change data
is sent from the MIDl foot controller immediately after
the power is turned on.
*
MIDI program change numbers receh•ed by the GR-33 have a
fixed one-to-one correspo11de11ce with the patches (001 to 128,
or All to D84) they represent; this cannot be clumged. (On
the other hand, w/1e11 patches arc selected usilrg tlze GR-33,
yo11 /rave the.freedom to change and save tire MIDI program
change n11111bers that send the data to outside eq11ip111e11t. ---,; p.
88)
Advertisement
Table of Contents
