Table of Contents
Advertisement
24:REVERB
Reverb adds reverberation to the original sound, simulating
an acoustic space.
Lout
Rout
TYPE (Reverb type)
Room 1 /Room2/Stage 1 /Stage2/Hall 1 /Hall2
Specify the type of reverb.
Room1:
Short reverberation with high density
Room2:
Short reverberation with low density
Stage1:
Reverberation with heavy subsequent reverberation
Stage2:
Reverberation with strong early reflections
Hall1:
Clear reverberation
Hall2:
Rich reverberation
PRE DELAY (Pre delay time) 0.0-100 ms
Specify the time delay from the original sound until the
reverb is heard.
TIME (Reverb time) 0-127
#
Specify the length of reverberation.
HF DAMP
200/2501315/400/500/630/800/1000/1250/1600/2000/2500/3150/
4000/5000/6300/8000 (200-8000 Hz), Bypass
Specify the frequency at which the high frequency portion of
the reverb sound will be cut.
Lower frequency settings will cause a greater portion of the
high range to be cut, producing a softer reverb sound.
If you do not want the sound to be cut, select Bypass.
LOW GAIN -15-+ 15 dB
Specify the gain (amount of boost or cut) of the low
frequency range.
Positive(+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN • 15-+ 1 5 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive ( +) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D 100:0E-DO: 1 00E
Specify the volume balance between the original sound and
the reverb sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the reverb sound
will be output.
LEVEL (Output level) 0-127
Specify the output volume.
Chapter 6 Using the Built-in Effects
I
25: GATE·REVERB
Gate reverb is a type of reverb effect which cuts the reverb
sound during its decay.
Lout
Rout
TYPE (Gatereverb type)
Normal/Reverse/Sweep 1 /Sweep2
Specify the type of reverb.
Normal:
Conventional gated reverb.
Reverse:
Reverse reverb.
Sweep1:
The reverb sound moves from right to left.
Sweep2:
The reverb sound moves from left to right.
PRE DELAY (Pre delay time) 0.0-100 ms
Specify the time delay from the original sound until the
reverb is heard.
GATE TIME 5-500 ms
Specify the length of the reverb sound.
LOW GAIN -15-+15 dB
Specify the gain (amount of boost or cut) of the low
frequency range.
Positive(+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN • 15-+ 15 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive ( +) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E-D0:100E #
Specify the volume balance between the original sound and
the reverb sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:lO0E only the rcvcrb sound
will be output.
LEVEL (Output level) 0-127
Specify the output volume.
67
I
Advertisement
Table of Contents
