Fujitsu fi-4860C Operator's Manual page 31

(2) In test mode ([Single feed] or [Multi feed], the Hopper height changes as follows
by pressing
1. When the Hopper is at the bottom position, it moves up to 250 sheet position.
2. When the Hopper is at 250 sheet position, it moves down to the bottom
position.
3. When the Hopper is at the highest position, it moves back where it was when
the scan operation started.
ATTENTION
HINT
8
1.3 Basic Operations of the Operator Panel
(Next button):
Pressing (Previous button) does not change the position.
The Hopper is positioned at the bottom when the power is
turned on.