Fujitsu fi-4860C Operator's Manual page 227

22. Setting Interface
1) Press (Next button) or
<Screen22>.
2) At <Screen22>, press
select the type of interface.
HINT
Available interface settings are as follows:
(1) [Auto] is blinking: If an interface board, either from third party or
(2) [SCSI] is blinking: SCSI interface is used. The interface on TPS is disre-
(3) [TPS] is blinking:
By pressing
By pressing
(3) Press
Press
screen.
204
7.3 Setup Mode Details
(Previous button) and let LCD display
<Screen22>
! 2 2
= A
(Left arrow button) or
The blinking item is the one selected.
optional, is installed in TPS, this interface is used. If
not, SCSI interface is used.
garded.
TPS interface is used. The SCSI interface is disre-
garded.
(Left arrow button), selection moves from (3) to (1).
(Right arrow button), selection moves from (1) to (3).
(Enter button) to confirm the setting.
(Exit button) at the end and the LCD display goes back to [Ready]
I n t e r f
u t o / S C S
(Right arrow button), and
a c e
I / T P S