Toyota verso User Manual page 553

CAUTION
■ When fixing the flat tire
●
To avoid risk of burst or severe leakage, do not drop or damage the bottle.
Visually inspect the bottle before use. Do not use a bottle with shock,
crack, scratch, leakage or any other damage. In such case, immediately
replace.
●
Connect the valve and hose securely with the tire installed on the vehicle.
If the hose is not properly connected to the valve, air leakage may occur
as sealant may be sprayed out.
●
If the hose comes off the valve while inflating the tire, there is a risk that
the hose will move abruptly due to air pressure.
●
After inflation of the tire has completed, the sealant may splatter when the
hose is disconnected or some air is let out of the tire.
●
Follow the operation procedure to repair the tire. If the procedures not fol-
lowed, the sealant may spray out.
●
Keep back from the tire while it is being repaired, as there is a chance of it
bursting while the repair operation is being performed. If you notice any
cracks or deformation of the tire, turn off the compressor switch and stop
the repair operation immediately.
●
The repair kit may overheat if operated for a long period of time. Do not
operate the repair kit continuously for more than 40 minutes.
● Parts of the repair kit become hot during operation. Be careful when han-
dling the repair kit during and after operation. Do not touch the metal part
around the connecting area between the bottle and compressor. It will be
extremely hot.
●
Do not attach the vehicle speed warning sticker to an area other than the
one indicated. If the sticker is attached to an area where an SRS airbag is
located, such as the pad of the steering wheel, it may prevent the SRS
airbag from operating properly.
VERSO_WE_OM64574E
5-2. Steps to take in an emergency
5
553