Cpas - Phone Activity Status; Cr - Service Reporting Control - Iridium 9523 Developer's Manual

Iridium Communications, Inc.
Iridium 9523 Product Developers' Guide
Revision 2.6
43 network subset personalization PUK required
44 service provider personalization PIN required
45 service provider personalization PUK required
46 corporate personalization PIN required
47 corporate personalization PUK required
100 unknown
Read Command: +CMEE?
Query mobile equipment error reporting level. The response is in the form:
+CMEE: <x>
Test Command: +CMEE=?
List the supported error reporting level. The response is in the form:
+CMEE: (supported <x>s)

5.7.29 +CPAS - Phone Activity Status

Exec Command: +CPAS
Query phone activity status. The response is in the form:
+CPAS: <x>
where <x> can take the following values:
0 Ready (allows commands)
1 Unavailable (does not allow commands)
2 Unknown (may not respond to commands)
3 Data Call Ringing (allows commands)
4 Data Call In Progress (allows commands)

5.7.30 +CR - Service Reporting Control

Set Command: +CR=[<mode>]
Set the service reporting level.
<mode> takes the following values:
0 Disable reporting (default)
1 Enable reporting
If reporting is enabled, the intermediate result code +CR: <serv> is returned by the Iridium 9523.
<serv> can have one of the following values:
ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL SYNC synchronous non-transparent
Iridium Communications, Inc.
Proprietary & Confidential Information
Only
Information Contained in this Guide
is Subject to Change Without Notice
Page 42 of 115
Distribution of Guide Restricted
to Product Developers