Informative Examples; Unit Identification; Setting The Default Configuration; Power-On To Sending An Sbd Message - Iridium 9523 Developer's Manual

Iridium Communications, Inc.
Iridium 9523 Product Developers' Guide
Revision 2.6

8 Informative Examples

Note: The examples below are presented in two different formats. The format used in each
example has no significance. A single format will be used in a future revision of this document.

8.1 Unit Identification

When beginning to build a communication link, a general FA application controlling the Iridium 9523
should confirm the type of Iridium device to which it is connected.
To Transceiver
(from FA)
AT+CGMI
AT+CGMM
AT+CGMR
AT+CGSN

8.2 Setting the Default Configuration

The FA sets the Transceiver's default configuration to no flow control, SBD automatic notifications
enabled.
To Transceiver
(from FA)
AT&K0
AT+SBDMTA=1
AT&W0
AT&Y0

8.3 Power-on to Sending an SBD Message

The FA will power up the Transceiver, wait for the Transceiver to acquire the network, and send a 70-byte
message.
To Transceiver
(from FA)
Iridium Communications, Inc.
Proprietary & Confidential Information
Only
To FA (from Transceiver)
Iridium
OK
<model ID>
OK
Call processor version: <revision>
DSP version: <revision>
...
OK
300001000000000
OK
To FA (from Transceiver)
OK
OK
OK
OK
To FA (from Transceiver)
Page 107 of 115
Information Contained in this Guide
is Subject to Change Without Notice
Description
Get manufacturer
name
Get model number
Get revision
Get IMEI
Description
Disable RTS/CTS flow control
Enable SBD ring indications
Store the configuration as profile 0
Select profile 0 as the power-up default
Description
Apply power to the Iridium 9523
Distribution of Guide Restricted
to Product Developers