Step 13 - Adjust Factory- -Installed Options; Step 14 - Install Accessories - Bryant 581Jx14 series Installation Instructions Manual

Step 13 — Adjust Factory- -Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Controls
Connections Board,
Shutdown". Cut jumper JMP 3 when ready to energize unit.
EconoMi$er IV Occupancy Switch —
Refer to Fig. 69 for general EconoMi$er IV wiring.
External occupancy control is managed through a
connection on the Controls Connections Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied sequence) at terminals marked
OCCUPANCY. Cut jumper JMP 2 to complete the
installation.
Step 14 — Install Accessories
Available accessories include:
Roof Curb (must be installed before unit)
Thru- - base connection kit (must be installed before unit
is set on curb)
Manual outside air damper
Two- - Position motorized outside air damper
EconoMi$er IV (with control and integrated barometric
relief)
EconoMi$er2 (without control/for external signal and
integrated barometric relief)
2015 Bryant Heating & Cooling Systems. D 7310 W. Morris St. D Indianapolis, IN 46231
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Economizer
Fig. 69 - - EconoMi$ert IV Wiring
at terminals marked "Smoke
2 Position Damper
Barometric relief
Power Exhaust
Differential dry- - bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
Time Guard II compressor anti- - cycle control
Outdoor coil protector grille
Head pressure control
Programmable setback thermostat
Electrical/Mechanical thermostat and subbase
Thermidistatt device
Humidistat
Thermostat / Sensors
CO sensor
2
Louvered hail guard
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
—
Pre- - Start and Start- - Up
This completes the mechanical installation of the unit.
Refer to the unit's Service Manual for detailed Pre- - Start
and Start- - Up instructions. Download the latest versions
from HVAC Partners (www.hvacpartners.com).
Edition Date: 01/15
42
Unit Without Economizer or
2 Position Damper
C10333
Catalog No: II581J---14---01
Replaces: II581J--- 07