Step 13 - Adjust Factory- -Installed Options; Step 14 - Install Accessories - Bryant 580J***D series Installation Instructions Manual

Single package rooftop gas heating/electric cooling unit with novation coil sizes 17, 20, 24, 28 with puron (r-410a) refrigerant
Hide thumbs Also See for 580J***D series:
Table of Contents

Advertisement

Step 13 — Adjust Factory- -Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Controls
Connections Board,
Shutdown". Remove jumper JMP 3 when ready to
energize unit.
EconoMi$er IV Occupancy Switch —
Refer to Fig. 50 for general EconoMi$er IV wiring.
External occupancy control is managed through a
connection on the Central Terminal Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied sequence) at terminals marked
OCCUPANCY on CTB. Remove or cut jumper JMP 2 to
complete the installation.
Step 14 — Install Accessories
Available accessories include:
Roof Curb
Thru- - base connection kit (must be installed before unit
is set on curb)
LP conversion kit
Manual outside air damper
High Altitude Gas kits
E2009 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Economizer
Fig. 50 - - EconoMi$ert IV Wiring
at
terminals
marked "Smoke
2 Position Damper
Flue Discharge Deflector
Flue Exhaust Heat Shield
Low Ambient Controls
Thermostat / Sensors
Two- - Position motorized outside air damper
EconoMi$er2 (without control/for external signal and
integrated barometric relief)
EconoMi$er2 (without control/for external signal)
Power Exhaust
Differential dry- - bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
CO
sensor
2
Louvered hail guard
Phase monitor control
Winter Start kit
Refer to separate installation instructions for information
on installing these accessories.
Pre- - Start and Start- - Up
This completes the mechanical installation of the unit.
Refer to the unit's Service Manual for detailed Pre- - Start
and Start- - up instructions.
Printed in U.S.A.
Edition Date: 06/09
32
Unit Without Economizer or
2 Position Damper
C08631
Catalog No. II580J---04
Replaces: NEW

Advertisement

Table of Contents
loading

Table of Contents