Goulds Pumps 3996 Installation, Operation And Maintenance Instructions page 7

GENERAL PRECAUTIONS
WARNING
A pump is a pressure vessel with rotating parts that can be hazardous. Hazardous fluids may be contained by the
pump including high temperature, flammable, acidic, caustic, explosive, and other risks. Operators and
maintenance personnel must realize this and follow safety measures. Personal injuries will result if procedures
outlined in this manual are not followed. ITT Goulds Pumps will not accept responsibility for physical injury,
damage or delays caused by a failure to observe the instructions in this manual and the IOM provided with your
equipment.
NEVER APPLY HEAT TO REMOVE IMPELLER. The use of heat may cause an
WARNING
explosion due to trapped fluid, resulting in severe physical injury and property damage.
WARNING NEVER use heat to disassemble pump due to risk of explosion from trapped liquid.
WARNING NEVER operate pump without coupling guard correctly installed.
NEVER run pump below recommended minimum flow when dry, or without prime.
WARNING
WARNING ALWAYS lock out power to the driver before performing pump maintenance.
NEVER operate pump without safety devices installed.
WARNING
WARNING NEVER operate pump with discharge valve closed.
WARNING NEVER operate pump with suction valve closed.
DO NOT change service application without approval of an authorized ITT Goulds
WARNING
Pumps representative.
Safety Apparel:
WARNING
Receiving:
Assembled pumping units and their components are heavy. Failure to properly lift and
support equipment can result in serious physical injury and/or equipment damage. Lift
equipment only at specifically identified lifting points or as instructed in the current IOM.
WARNING
Current manuals are available at www.gouldspumps.com/literature_ioms.html or
from your local ITT Goulds Pumps sales representative. Note: Lifting devices (eyebolts,
slings, spreaders, etc.) must be rated, selected, and used for the entire load being lifted.
General Precautions
Insulated work gloves when handling hot bearings or using bearing heater
Heavy work gloves when handling parts with sharp edges, especially impellers
Safety glasses (with side shields) for eye protection
Steel-toed shoes for foot protection when handling parts, heavy tools, etc.
Other personal protective equipment to protect against hazardous/toxic fluids
S-4