3] Rps > [3] Rps Ip Address Menu Parameters; 3] Rps > [4] Rps Port Number Menu Parameters - Bosch D9412GV4 Installation And System Reference Manual

D9412GV4/D7412GV4 v2.03 | Installation and System Reference Guide | 18.0 Installer Menu
.
18.1.10 [3] RPS > [3] RPS IP Address Menu Parameters
The control panel allows for enhanced communication to occur over the SDI bus. In this menu, you
can program the IP address for RPS communication.
RPS IP Address
B91x/B92x keypads Configuration of RPS IP Address
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [3] RPS > [3] RPS IP Address menu option.
3. Press [ENTER] to edit RPS IP Address.
4. Use the [PREV] or [NEXT] key to toggle between the option to edit the address as an IPv4
address or hostname. Press [ENTER] when the keypad shows the option you wish to edit.
5. Delete existing characters, if necessary, and then enter the new characters. Use [PREV]
or [NEXT] to move to a different byte.
6. Press [ENTER] to save the programming.
7. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads Configuration of RPS IP Address
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [3] RPS > [3] RPS IP Address menu option.
3. Press the Edit IPv4 softkey for an IP address, or the Edit DHCP softkey for a host name.
4. Delete existing characters, if necessary, and then enter the new characters. Use [PREV]
or [NEXT] to move to a different byte.
5. For an IPv4 address, use the [PREV]/
use the number keys to enter the new numbers. For host name, press a number key repeatedly
to scroll through the number and letters shown on the key.
6. Press the Save softkey.
7. When the keypad shows Parameter Saved, escape from the menu.
18.1.11 [3] RPS > [4] RPS Port Number Menu Parameters
In this menu, you can specify the destination port for outgoing RPS session requests to the specified
IP address.
RPS Port Number
B91x/B92x keypads Configuration of RPS Port Number
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [3] RPS > [4] RPS Port Number menu option.
3. Press [ENTER] to edit RPS Port Number parameter.
4. Delete existing characters, if necessary, and then enter the new characters. Use [PREV]
or [NEXT] to move to a different byte.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
Bosch Security Systems, Inc. | 7/16 | F01U265457-09
and [NEXT]/ keys to move to a different byte, and
122