Section1 Airframe Assembly - Elite Models 8mm EPP Acrocub Instruction Manual

Note: 1. Allowing the foam glue to set for a few minutes before assembly will shorten tack up time. This will
help you secure the bond more quickly, as the glue usually take longer to cure than needed. Any joints that
you feel are going to require adjustment, it is best to assemble the pieces while the glue is wet so you will
have time to make adjustments.
2. Use low temperature hot glue for gluing electronics. This will allow for easy removal later. The low
temperature hot glue can be loosened by swabbing the glue joint with alcohol.

Section1 Airframe Assembly

Step1. Locate the fuselage half and two CF strips.
Long one (240 x 8 x 1mm) and short one (133 x 8 x
1mm).
Step2. Apply some foam glue to the CF strips.
Step3. Slide two CF strips into the pre-cut slots.
Step4. Locate two gear leg plywood tips.
www.valuehobby.com/8mm-epp-acrocub.html
Step5. Use thin CA to glue them together.
Step6. Use foam glue to glue in the gear leg tips.
6