Elite Models 8mm EPP Acrocub Instruction Manual page 16

Step23. Start to install elevator servo linkage.
Install the elevator control horn.
Step24. Attach the pushrods to the control horn
and elevator servo arm.
Step25. Insert 4-5 guides into the fuselage for
elevator pushrod (370 x 1mm).
Slide the pushrod into the guides.
www.valuehobby.com/8mm-epp-acrocub.html
16
Step26. Use a lighter to shrink the tubing to
connect the z bend wire to the pushrod.
Step27. With the elevator centered, cut off the
excessive pushrod and use a lighter to shrink the
tubing to connect the z bend wire to the pushrod.
Step28 Repeat the previous steps to finish the
rudder servo link installation.