Section2 Wheels Installation - Elite Models 8mm EPP Acrocub Instruction Manual

Section2 Wheels Installation

Step1. Locate the foam parts and wood hubs for
the wheel assembly.
Step2. Glue them together as shown.
Make sure the holes on the wood hubs and solid
EPP foam are aligned with each other.
Step3. Locate two axles (60 x 2mm).
Step4. Use hot glue to install the axle to the
plywood gear leg tip.
Make sure the axle is parallel with the work surface
and part of axle stick out to the inside.
Step5. Locate the sewing thread as shown.