HYT TC-518 Owner's Manual page 9

Target Radio
Power On
Low Battery Alert
Transmitting
Receiving
Scanning
Programming
Power Adjust
VOX/Compandor/Scrambler/Channel Lock
(9) Microphone
(10)Speaker
(11) Battery Latch
(12) Earpiece Jack & Programming Port
(13) Accessory Cover
(14) Belt Clip
(15) Battery
(16) Screw, Belt Clip
(17) Charging Piece
TC-518 Owner's Manual
1. The LED flashes green when cloning is in
progress.
2. The green LED goes out when cloning is
completed.
1. The power-on alert tone is heard when the
radio is powered on.
2. When the current channel is idle, beeps are
heard.
The LED flashes red and the low pitched tone
is heard every ten seconds.
1. Red LED.
2. When transmission times out, beeps are
heard.
3. TOT Pre-alert: One beep is heard.
The LED glows green when carrier presents.
1. The LED flashes green every 1 second
when detecting.
2. Scan Start Tone (programmable by your
dealer): One beep is heard.
3. Scan Stop Tone (programmable by your
dealer): One beep is heard.
Reading: The LED flashes red.
Writing: The LED flashes green.
From High to Low Power: The low pitched tone
is heard.
From Low to High Power: The high pitched
tone is heard
Enable VOX: A high pitched tone is heard.
Disable VOX: Two continuous pitched tones
are heard.
7