Strip the glass surface web by web from
top to bottom by means of the rubber lip
and vacuum off.
Wipe the rubber lip and the lower win-
dow frame dry as necessary.
Upholstery nozzle (small)
It is suitable to vacuum up dirt from nar-
row surfaces, such as tile joints, door
frames, roller shutter slits, etc.
Upholstery nozzle (large)
For cleaning textile surfaces such as
sofas, armchairs, mattresses, car
seats, etc..
Crevice nozzle
For edges, joints, heaters and hard to
reach locations.
Furniture brush
For cleaning sensitive surfaces such as
picture frames, books, etc..
Special accessories
Round brush kit (order No. 2.860-231) 4
round brushes for the detail nozzle.
HEPA Filter (Order No.. 2.860-229)
Care and maintenance
DANGER
Mortal danger due to electric
current.
Turn off the appliance and re-
move the mains plug prior to
any care and maintenance
work.
Allow device to cool down.
Repair works may only be
performed by the authorised
customer service.
30
Do not set the brushes onto the bristles
during cooling or drying so that they do
not deform.
Use a moist cloth for cleaning the ma-
chine from the outside. Avoid using any
solutions or cleaning agents as they
can damage the plastic surface.
For cleaning the water filter container,
see Chapter "Storing the appliance".
Check the condition of the seals in the
steam plug regularly. Replace them as
necessary.
Perform the same check for the con-
nection seals of the steam pipes and
the handle.
HEPA filter
ATTENTION
Material damage due to incor-
rect cleaning of the HEPA filter.
When necessary, clean un-
der running water only, do not
wipe or brush down.
Removal of the water filter container,
see Chapter "Filling the water filter con-
tainer".
Illustration
Lift the unhooking lever of the HEPA filter
and remove the filter from the seating.
Rinse the HEPA filter under cold, run-
ning water.
Shake the filter carefully after cleaning
so that any residual dirt or excess water
is removed.
Note
Allow the HEPA filter to be air-dried by light
and heat sources. Only reinstall the dry
HEPA filter into the appliance.
Replace the HEPA filter in case of dam-
age
The HEPA filter should be cleaned at in-
tervals of 4 months.
Ensure the correct positioning of the
HEPA filter in the holder.
Relock the HEPA filter by means of the
lever.
– 16
EN
Care
Maintenance