Steam And Vacuum Cleaning Operation; Putting Down The Accessories; Energy Saver Mode; Storing The Appliance - Kärcher SV 7 Operating Instructions Manual

Steam and vacuum cleaning
operation
Illustration
 Push the main switch.
The first level of the indicator lamps for
the suction performance starts to flash.
Illustration
 Push the steam boiler switch, the switch
lights up.
 Wait until the indicator lamp for the
pressure indication is on.
The appliance is now ready for steam
operation.
Illustration
Illustration
 Simultaneously push the steam button
and briefly the suction button on the
handle.
The suction operation starts with the
minimum performance and steam is
discharged simultaneously.
For further use of the steam and vacuuming
function see Chapter "Steaming operation
and vacuuming operation"

Putting Down the Accessories

Illustration
 Place the steam suction pipe in the
parking holder during interruptions of
work.

Energy saver mode

If the appliance is not used for more than 15
minutes, it automatically changes into the
standby mode and the boiler switches off.
The first stage of the indicator lamp for the
suction performance starts to flash more
slowly as with the normal switch-on of the
suction indicators.
There are the following options for recom-
missioning:
Abbildung
 Switch the main switch off and back on.
or
Illustration
Illustration
 Push the steam button or suction button
for at least 3 seconds.
Finish operation
Illustration
 Push the main switch.
Illustration
 Separate the mains cable from the pow-
er supply system.
Illustration
 Disconnect the steam plug from the ap-
pliance. Hold the steam plug lock down
and pull the steam plug out of the appli-
ance connector.

Storing the Appliance

ATTENTION
Material damage due to a lack of
cleaning the accessories after use.
Always thoroughly clean all

accessories prior to storing
the appliance.
 Disconnect all accessories.
 Rinse all accessories with clear water
under a tap.
 Rinse pipes and steam suction hose
with clear water using the pipe cleaning
brush.
 Allow accessories to dry afterwards.
 Store the appliance at a dry and frost-
proof location.
Emptying and cleaning the water filter
container
Illustration
 Lift the handle of the water container.
 Pull out the water filter container.
Illustration
 Turn the handle towards the back.
 Remove the water filter insert.
Illustration
 Draining the water filter container by tilt-
ing it towards the pouring device.
Illustration
 Pull the pipe bend off the filter casing
with the grid with the micro-perforation
until it is completely removed.
– 13
EN 27