Assembly -Wgen3600; Installing Wheels And Feet - Westinghouse WGen3600 User Manual

ASSEMBLY - WGen3600

INSTALLING WHEELS AND FEET

BEFORE ASSEMBLING THE
GENERATOR, REVIEW THE SAFETY
SECTION STARTING ON PAGE 5.
Never lift the generator without
assistance. The generator is heavy
and lifting without assistance could
result in personal injury.
Never use the handles as a lifting point
to support the entire weight of the
generator. Only use the handles to move
the generator by lifting the handles and
using the wheels to move the generator.
Use caution when collapsing the
handles. Hands and fingers could get
caught and pinched.
NOTICE
Assembling the generator will require lifting the unit
on one side. Make sure all engine oil and fuel are
drained from the unit prior to assembling. Once
assembled, the wheel kit is not intended for on-
road use. The wheel kit is designed for use on this
generator only.
INSTALLING FEET TO FRAME
(WGen3600 Only)
1. Place generator on a flat surface.
2. Place a piece of cardboard or other soft material to
tip the generator onto, to protect the frame paint
and prevent the generator from sliding. Tip the
generator onto the side.
3. Install the mounting foot to the frame using M8
flange bolts.
1 - Mounting Feet
2 - Flange Bolts M8
Figure 1 - Assemble Mounting Feet to Frame
10 | Westinghouse Portable Power
CAUTION
INSTALLING WHEELS TO FRAME
(WGen3600 Only)
1. Insert axle pin through washer and wheel.
Figure 2 -Wheel Assembly
2. Install the wheel with axle pin through the axle
bracket on the frame. The eye of the bolt should be
facing toward the inside of the generator.
2
3
Figure 3 - Assemble Wheel to Frame
3. Install the hairpin cotter through the axle pin to lock
it in place.
1 - Axle Bracket
2 - Hairpin Clip
3 - Axle Pin
4. Repeat previous steps on other wheel.
1