State Of Charge; Leds On Battery; Led On Charger; Assembling The Saw - Stihl MSA 120 C Instruction Manual

English
► Insert the plug (6) in a convenient wall outlet (7).
The charger (3) runs a self test. The LED (4) glows green
for about 1 second and then red for about 1 second.
► Lay the connecting cable (5).
► Insert the battery (2) in the guides in the charger (3) and
press it home as far as stop.
The LED (4) glows green.
The LEDs (1) glow green and show the state of charge.
► If the LED (4) and the LEDs (1) stop glowing: Disconnect
the plug (6) from the wall outlet (7).
Battery is fully charged.
► Remove the battery (2).
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on Battery

The LEDs can indicate the state of charge of the battery or
faults in the chain saw or the battery. The LEDs can be
green, red or flashing.
If the LEDs are glowing or flashing green, this indicates the
state of charge of the battery.
18
► If the LEDs are glowing or flashing red: Rectify faults
@ 19.
There is a fault in the chain saw or in the battery.
6.4
The LED indicates the operating status of the charger.
If the LED glows green, the battery is being charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.

7 Assembling the Saw

7.1
7.1.1
80-100%
60-80%
The bar and chain combinations that can be used with the
40-60%
chain sprocket are listed in the specifications, @ 21.
20-40%
► Switch off the chain saw, engage the chain brake and
remove the battery.
0-20%
► Raise the grip (1) of the wingnut (2).
► Rotate the wingnut (2) counterclockwise until the chain
sprocket cover (3) can be removed.
► Remove the chain sprocket cover (3).

LED on Charger

Mounting and Removing the Bar and Chain

Mounting the Bar and Chain
1
3
7 Assembling the Saw
2
0458-716-0121-B