Backside; Installation; Set Up And Operation - DAPAudio PMM-401 Manual

PMM-401

Backside

Balanced input 1/4" TRS jack, channel 4
Balanced input 1/4" TRS jack, channel 3
Balanced input 1/4" TRS jack, channel 2
Balanced input 1/4" TRS jack, channel 1
Balanced output 1/4" TRS jack, channel 4
Balanced output 1/4" TRS jack, channel 3
Balanced output 1/4" TRS jack, channel 2
Balanced output 1/4" TRS jack, channel 1

Installation

Remove all packing materials from the PMM-401. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Install this device only on a flat surface.
Do not supply power before all components of the system are set up and connected properly.
Make sure to power-up your PMM-401 before your power amplifiers are switched on in order to avoid
loud transients, which could damage your speakers or annoy your audience.
Ordercode: D1531
6
Fig. 02