Genie Z-45/22 Service Manual page 67

Service Manual - Second Edition
800-610-4101
ActionRental.com
4 Remove the 3 bolts from the engine pivot plate.
Swing the engine pivot plate away from the
machine to access the radiator petcock.
a
a
5 Open the petcock on the radiator and allow
all the coolant to drain into a container.
6 After all the coolant has drained, close the
petcock. Connect the coolant return hose to
the radiator.
7 Open the petcock on the engine block and allow
the coolant to drain into a container.
After the fluid is drained, close the petcock.
8 Replace all coolant hoses and clamps.
9 Pour the proper coolant mixture (anti-freeze and
water) for your climate into the radiator until it is
full.
Part No. 32960
a
pivot plate retaining bolts
Section 4 - Scheduled Maintenance Procedures
10 Disconnect hose A from hard line B and hold
until coolant starts to pour out of the open hose.
Then immediately reconnect the hose.
a
a
11 Fill the radiator and then fill the coolant recovery
tank to the
NORMAL
12 Clean up any coolant spilled during this
procedure.
13 Start the engine from the ground controls,
run it for 30 seconds, and then turn it off.
14 Inspect for leaks and then check the fluid
level in the coolant recovery tank. Add
water if needed.
15 Start the engine from the ground controls
and run it until reaching normal operating
temperature.
16 Allow engine to cool and check the fluid level in
the coolant recovery tank. Add water if needed.
Ford Engine LSG-423
Coolant capacity
Genie Z-45/22
TABLE D PROCEDURES
a hose A
b hard line B
range.
11.5 quarts
b
10.9 liters
4 - 37