Genie Z-45/22 Service Manual page 39

Service Manual - Second Edition
800-610-4101
ActionRental.com
2 Pull the end of the oil drain hose out from
under the engine.
a b
a
b
c
3 Remove the plug from the end of the drain
hose and allow all of the oil from the engine
to drain into a suitable container.
4 Install the plug into the drain hose.
5 Remove the 3 bolts from the engine pivot plate.
Swing the engine pivot plate away from the
machine to access the oil filter.
6 Use an oil filter wrench and remove the filter.
7 Apply a thin layer of oil to the new oil filter
gasket (filter part no. 28656). Then install the
filter and tighten it securely by hand.
8 Use a permanent ink marker to write the date
and number of hours from the hour meter on
the oil filter.
9 Fill the engine with new oil per specifications
and install the filler cap.
10 Start the engine from the ground controls.
Allow the engine to run for 30 seconds, then
turn the engine off.
11 Check the oil filter and the oil drain hose
for leaks.
Part No. 32960
c a a
pivot plate retaining bolts
engine pivot plate
oil drain hose
Section 4 - Scheduled Maintenance Procedures
12 Swing the engine pivot plate back to its original
position and replace the three retaining bolts.
13 Check the engine oil level dipstick. Add oil
if needed.
Ford Engine LSG-423
Oil capacity (including filter)
Ford Engine LSG-423 Oil viscosity requirements
below 60F / 15.5C
-10 to 90F / -23 to 32C
above -10F / -23C
above 25F / -4C
Use oils meeting API classification SF (labeled SF/CC
or SF/CD) as they offer improved wear protection.
Genie Z-45/22
TABLE A PROCEDURES
5 quarts
4.7 liters
5W-30
10W-30
10W-40 or 10W-50
20W-40 or 20W-50
4 - 9