Physical Installation - Dome DMWS1 User Manual

The device should already be included in your Z-Wave system before continuing
further. Study the Pre-Installation Checklist below for a broad overview of in-
stallation options and other notes to bear in mind
Pre-Installation Checklist
9 The MAIN BODY CRADLE and REMOTE SENSOR PROBE are optional, to
help monitor hard-to-reach areas—study Figures 3 and 4 to understand
when, where, and why to use the REMOTE SENSOR PROBE
9 The Leak Sensor detects moisture the moment water contacts the
METAL FEET on the REMOTE SENSOR PROBE or the MAIN BODY BASE
9 To monitor a pipe or appliance for leaks, place the Leak Sensor nearby on
a flat surface where water is likely to accumulate during a leak
9 If there is not enough space for the SENSOR ASSEMBLY to fit, use the
optional REMOTE SENSOR PROBE
9 When using the REMOTE SENSOR PROBE, the SENSOR ASSEMBLY will
rest in the MAIN BODY CRADLE
9 All three METAL FEET should contact the surface
9 The REMOTE SENSOR PROBE can also hang mid-air to monitor rising water
levels (for example in a sump pump pit)
LEAK
Figure 3 - Leak Sensor Installation Without the
REMOTE SENSOR PROBE
Leak Sensor Advanced User Manual

Physical Installation

Physical Installation
MAIN SENSOR
SENSOR ASSEMBLY
LEAD
REMOTE SENSOR PROBE
Figure 4 - Leak Sensor Installation With the
REMOTE SENSOR PROBE
Page 9