Factory Reset & Misc. Functions - Dome DMWS1 User Manual

Factory Reset & Misc. Functions
Resetting the Leak Sensor
If needed, the Leak Sensor can be reset locally by following these steps. Only
do this when your Z-Wave controller is disconnected or otherwise unreachable.
Beware that resetting your device will disconnect it from the system:
1. Remove the MAIN BODY COVER and confirm that your Leak Sensor is pow-
ered up.
2. Press and hold the CONNECT BUTTON for at least 10 seconds then release.
A flashing light indicates a successful factory reset.
3. The Leak Sensor's memory will be erased to factory settings.
Waking Up The Leak Sensor
Because the Leak Sensor is a battery powered device, it wakes up on regular
intervals to give battery and other status updates to the controller, as well as to
accept configuration settings from the controller. This helps to extend the bat-
tery life. The device can be forced to wake up to submit these reports or accept
new settings immediately by simply pressing and holding the BUTTON for two
seconds. The LED INDICATOR will flash once indicating successful wake up.
Leak Sensor Advanced User Manual
Factory Reset & Misc. Functions
Page 8