Configuration Parameters - Dome DMWS1 User Manual

Configuration Parameters

Configuration parameters are sent using a standard syntax to ensure interopera-
bility between all manufacturers' products. All values are represented using the
hexadecimal number system.
Typical syntax is as shown below. Note that the value sent must be the exact size,
in bytes, as accepted by the setting. The "extra" spaces should be filled with zeros
(see the "value" column below.)
Example Configuration Parameter: 02 02 00 0A
Param #
(Param #2)
Param
# Size
This parameter enables or disables the audible alarm ("beeping") functionality of the Leak Sensor.
05
01
Enable/Disable Audible Alarm
This parameter enables or disables the Leak Sensor - if disabled, the device will not respond in any way to detected
06
01
Enable/Disable Water Detection
This parameter defines the value sent by the BASIC_SET command to Association Group 2 (for more information,
07
01
Leak Sensor Advanced User Manual
Configuration Parameters
02
(2 Bytes)
Name
see "Assocation Groups".)
Basic Set Level
Table 6 - Configuration Parameters
Size
02
Available Values
00
(Audible Alarm Disabled)
01
(Audible Alarm Enabled)
leaks.
00
(Water Detection Disabled)
01
(Water Detection Enabled)
00
(0/Turn Off Device)
01 ~ 63
(0-99)
FF
(255/Turn On Device)
Value
00 0A
(10)
Default
Value
01
(Audible
Alarm
Enabled)
01
(Water
Detection
Enabled)
FF
(255/Turn
On Device)
Page 15