153
BELT TENSIONER ASSEMBLY
Removal and Replacement
1.
Power off.
2.
Remove the printer covers (110).
3.
Loosen the carrier to belt clamp
II
and slip the
belt out of the clamp. For installation, ensure belt
alignment" is correct before tightening the
clamp
II
and the screw
D·
4.
Remove the belt from the motor pulley.
5.
6.
Remove the screw
D.
Then, remove the tensioner
assembly. When reinstalling, do not tighten the
screw until alignment is completed.
To reinstall, reverse this procedure.
Carrier Bracket
Belt Clamp
80
cps
and 120
cps
Belt Tensioner Assembly
D
Move the belt tensioner assembly to get
proper belt alignment as shown at
e.
Underside View of Printer in
Service Position
Belt Clamp
Carrier Bracket
40
cps
1-42