Table of Contents
Advertisement
162
PRINT HEAD CABLE (EC1)
Removal
1.
Power off.
2.
Remove the printer covers (110).
3.
Remove the print head (160). Adjust the print
head on installation.
4.
Separate the printer from power supply board
A 1 (115). Observe the cable path to aid in
installing the cable.
5.
Note how P2B is connected and remove P2A and
P2BD·
6.
CAUTION
When loosening the mounting screws for the print .
emitter pickup, the coil spring
II
is released.
Loosen the print emitter pickup cable clamp
II.
Remove the clamp screw on the left side and
remove the wires from under the clamp.
fI
D
7.
Loosen the belt clamp
II.
Remove the cable
clamp. bracket
II
(2 screws).
1-46
8.
Work the cable out of the holes in the casting
II
and push the connector through the hole.
9.
Remove the 2 screws from the cable clamp
assembly
II
(the long flat spring with plastic on .
the ends).
10.
Remove the old cable.
Underside View of Printer
in Service Position
Advertisement
Table of Contents
