Table of Contents
Advertisement
Printer Emitter Pickup and Amplifier Removal and
Replacement
1.
Separate the printer from power supply board A 1
(115) and place the printer in the service position.
2.
For installation, adjust the left margin (143).
3.
Verify that P2A
II
and P28
II
are connected as
shown on the safetY cover label; if they are not,
record the way they are connected.
4.
Disconnect P2A and P28.
5.
For installation, adjust the print emitter pickup and
amplifier card (140).
6.
CAUTION
The coil spring
B
is released when the pickup
mounting screws are removed.
Remove 2 screws
II
that hold the pickup to the
carrier.
7.
Reinstall the pickup by reversing this procedure.
140
Remove. Replace.
Adjust
DO
Underside View with Printer in Service Position
Maintenance
5256 MIM
1-37
Advertisement
Table of Contents
