Electrical Connections - Webasto Air Top 2000 ST Installation Instructions Manual

Boat Air Heaters
Air Top 2000 ST / Evo 40 / Evo 55
9

Electrical Connections

The free ends of all lines that are not required must be insulated!
9.1. Electrical system, general
• Observe all information and safety precautions!
• Install a clearly visible operation indicator to show whether the heat-
ing is switched on or off (requirement from 2001/56/EC). This is al-
ready integrated in the Webasto control elements.
• Install all wiring harnesses and electrical components in dry and pro-
tected areas!
• The free ends of all lines that are not required must be insulated.
• If there is highly sensitive electronic equipment on board, special
electrical interference suppression measures may be necessary. Con-
tact an authorised Webasto partner.
• Do not touch exposed PCBs of the unit (electrostatic discharge).
• For connector designations see the legend and wiring diagrams,
Page 87.
9.2. Wiring harnesses
Fig. 33 and Fig. 34 show the wiring harnesses for Air Top 2000 ST and
Air Top Evo 40 / Air Top Evo 55
Electrical system
Fig. 33 Wiring harness Air Top 2000 ST
79