Setting The Date And Time; Use Of The Chronograph - Victorinox Chrono Classic XLS Instructions For Use Manual

01_Ronda 5130_GB:ME chronograph Europe

1. SETTING THE DATE AND TIME

NOTE: The Chrono Classic XLS Alarm does
not have a second counting hand in the time
function.
Setting the date and time:
1. Pull the crown out to position 2.
Turn the crown
2. clockwise until yester-
day's date appears.
3. Pull the crown out to position 3 (the alarm
display changes from alarm time to reference time). You will see the hand mov-
ing in the alarm time subdial till they show the alarm reference time. Please wait
till hands stop moving.
4. Turn the crown clockwise until correct date appears (at 12 midnight).
5. Continue to turn the crown to desired time.
6. Push in the crown to position 1 (the alarm display changes from reference time
to alarm time). Watch will resume working.
7. You will see the alarm subdial will turn till reaching the set alarm time.
Rapid date adjustment:
1. Pull the crown out to position 2.
2. Turn the crown until correct date appears.
3. Push the crown back to position 1.
6
3/06/08 16:49 Page 6
English English
Please note: Resetting the time also requires the identical correction of the refer-
ence time – please refer to 3. Setting the reference time.
the morning when the date mechanism is in action. Be careful not to confuse mid-
day and midnight.
1 2 3

2. USE OF THE CHRONOGRAPH

F 12-hour counter
G 60-second counter
H 30-minute counter
Single event:
1. Press pusher A to start the chronograph.
2. Press pusher A again to stop the chrono-
3. Press pusher B to reset to zero.
Please note: The alarm cannot be used as
long as the chronograph is in operation.
Intermediate/split time function:
The intermediate/split time function enables users to stop the hands to read an inter-
To avoid any errors, do not perform this operation between 21.00 and 03.00 in
graph.
7