Setting The Alarm Time; Adjusting The Chronograph Hands To Zero Position - Victorinox Chrono Classic XLS Instructions For Use Manual

01_Ronda 5130_GB:ME chronograph Europe
– If you wait for more than 10 seconds, the reference time setting mode will deac-
tivate automatically (1 beep will occur).
– A signal indicates alarm is switched off.

4. SETTING THE ALARM TIME

NOTE: The alarm cannot be adjusted while
the chronograph is active and the alarm has
to be initially synchronised with the reference
time (See Step 3. Setting the reference
time).
M Alarm time subdial:
N Minute hand
O Hour hand
Activate the setting mode:
Set the crown to position 1. Press the pusher
B for at least 2 seconds. As soon as the small
minute hand in the subdial jumps forward
one minute, the mode is active.
NOTE: The alarm time setting mode will deactivate automatically after 10 seconds if
there is no manipulation. Two beeps will indicate that alarm is switched on.
10
3/06/08 16:49 Page 10
English English
Setting:
Short pressing (less than 1 second): the alarm time is moved forward by the minute.
Long pressing (more than 2 seconds): the alarm time is moved forward until the
pusher is released.
Switching the alarm on/off:
2 beeps: alarm switched on
1 beep: alarm switched off.
NOTE: The alarm can be set maximum 12 hours before the desired alarm time. Once
the set alarm time has been reached, a signal is emitted for 20 seconds. This signal
is repeated after two minutes. Following brief pressing of the pusher B, the signal is
immediately switched off.
The alarm beeps only once and has to be reactivated every day by pressing shortly
the pusher B.

5. ADJUSTING THE CHRONOGRAPH HANDS TO ZERO POSITION

In case the chronograph hands do not show zero seconds zero minutes/hours after
resetting:
– Pull the crown out to position 3.
– Keep pusher A and B depressed simultaneously for at least 2 seconds (the cen-
ter stop-second hand rotates 360°: corrective mode is activated).
11