Registration Of Your Preamplifier - Rogue Audio RP-5 Manual

 If hum can be heard from more than a few inches from the loudspeaker, there
is probably a ground loop. Be sure to have the amp and all sources plugged
into the same outlet if possible. If this fails to cure the hum, call customer
service at Rogue Audio for further advice 570-992-9901.
Unit does not turn on
 Check that the power cord connection is secure and that the rear power switch
is turned on
 Turn off the main power switch on the rear of the RP-5. Wait one minute then
turn the rear panel switch back on. Wait 30 seconds then press the power
button on the front panel (e.g. reboot).
Unit does not play
 Check that the interconnects are connected to the proper input or output.
 Check that the interconnects are connected securely.
 Processor button is pushed in with no processor or with the processor turned
off.
 Tape monitor button is pushed in with no signal.
One channel does not play
 Check that the balance pot is centered.
 Check that the tubes are seated correctly and securely
For further problems, please call Rogue Audio Technical Support at 570-992-9901.
OWNER AND WARRANTY REGISTRATION FORM
Included with this manual is an Owner and Warranty Registration Form. Please
take a minute to fill out this card and return it to Rogue Audio. This card must be
returned within 30 days of purchase to validate the warranty.
10