The reaction of the device to a power failure and after wake events is specified in the
"Power" menu. The following figure shows an example for the "Power" menu.
DeepSx Power Policies
Wake on LAN
Wake on PME or LAN 2 (X2 P1)
Auto Wake on S5
Operating Manual, 05/2016, A5E33664825-AB
If enabled (Enabled), the devices switches itself to idle state,
a mode with the lowest power consumption. The
DeepSx-Modes for the operating states S4 and S5 are
switched on for this purpose.
Some functions, for example Wake on LAN, that demand an
activity from parts of the device, are then no longer possible.
When enabled (Enabled), a USB port is configured so that it
remains enabled when the device is disabled and mobile
phones or tables are still loaded.
Device switches on (Enabled) when a Power Management
Event or an event over LAN occurs, or does not switch on at
these events (Disabled).
By Every Day
By Day of
BIOS Setup (SCU)
The device does not switch on when it is in
the operating state S5.
The device switches on each day when it is
in the operating state S5. Specify the time
The device switches on each month when it
is in the operating state S5. Specify the time
of day and the day.
3.6 Power menu