Siemens SIMATIC IPC627D Operating Manual page 25

Parameter
Per-Port Control
The following Setup parameters depend on the hardware configuration of your device and are visible
if "Per-Port Control" is enabled:
•
•
•
•
•
•
•
•
•
•
•
•
Only with Field programming device
1
Only with IPC4x7
2
Only with IPC647 and IPC847
3
"Chipset Configuration (Miscellaneous)" submenu
BIOS Description
Operating Manual, 05/2016, A5E33664825-AB
Meaning
The USB ports cannot be individually disabled (Disabled): All ports are
enabled by default.
If Per-Port Control is enable (Enabled), the list of USB ports is shown:
Individual ports cannot be separately enabled or disabled. The enable
status of all ports is saved and appears each time if Per-Port Control is
enabled.
Enable (Enabled) or disable (Disabled) USB port.
USB Port 0
USB Port 1
Applies only to IPC277E: USB Port 2 is visible depending on the ordered
USB Port 2 device configuration. If USB Port 2 (USB hub) is disabled, Port 5
(Front/MutliTouch), Port 6 (Single Touch) and Port 7 (Internal) are
USB Port 3
disabled.
USB Port 4
USB Port 5
USB Port 6
USB Port 7
USB Port 8
USB Port 9
USB Port 10
3
USB Port 11
3
BIOS Setup (SCU)
3.4 Advanced menu
25