Camera Settings For Reading Bar Codes - Intermec CN51 User Manual

Camera Settings for Reading Bar Codes

Document Title
2 Position the computer about 20 cm (8 in) over the bar code you
want to read. Make sure nothing is blocking the camera lens.
3 Press and hold the Scan button. The screen turns into a viewfinder
with an aiming bar across the middle of the screen.
4 Center the aiming bar over the bar code and release the Scan
button. The bar code is read and the data appears in the active
application.
If the computer does not read the bar code right away, release the
Scan button and try again. You may need to move the computer
closer to or further away from the bar code for best results.
To use the camera for reading bar codes, you must use the Intermec
Settings application to configure the camera. From the main screen of
Intermec Settings, select Data Collection > Camera > Camera
Settings.
Optimized Imager Mode (Advanced) Settings and Descriptions
Setting Description
Imager decode
mode
Lighting mode
Lighting goal
Illumination level
Initial 1D search
area
Damaged 1D codes
DRAFT
Chapter 4 — Use the Camera
Choices
•
Linear imager
emulation
•
2D imager
•
Illumination
LED priority
•
Aperture priority
Default is 30.
Default is 3.
•
Center
•
Full
•
Smart raster
•
Disable
•
Enable
63