Advertisement
Advertisement
Table of Contents
Related Manuals for Atlantic O’Pro 272014
Summary of Contents for Atlantic O’Pro 272014
- Page 1 O’Pro electric storage water heater PREMIUM SERIES – MAINS PRESSURE ELECTRIC STORAGE WATER HEATERS DOCUMENTATION FOR INSTALLATION AND OPERATION New Zealand INDOOR INSTALLATION ONLY MODEL 272014 150 Litre MODEL 282029 200 Litre MODEL 282035 250 Litre MODEL 292039 300 Litre...
- Page 2 Congratulations on purchasing an Atlantic hot water system. Atlantic’s quality hot water systems are engineered to provide abundant hot water, efficiently and trouble free for many years. To keep track of your warranty, please register this purchase at our web site www.atlantic.nz...
- Page 3 Warning This device is not intended for use by persons (including children) with physical, sensory or mental disability, or by persons lacking experience or knowledge, unless they have received from a person in charge of their safety adequate supervision or preliminary instructions on how to use the device.
-
Page 4: Hydraulic Connection
Hydraulic Connection PTR valve (850 kPa) Untempered Hot water (Kitchen, Laundry) Tempered water 50°C (Bathrooms) Cold water 1. Non-return and isolating valve 2. Line Strainer 3. Pressure Limiting valve (350-500 kPa) 4. Expansion Control valve Drain Lines... -
Page 5: Cold Water Inlet
Mandatory installation of a safety device in a frost free location (or any other new device which limits the tank pressure) to 850 kPa according to the nominal pressure, with a size of 3/4’’ on the input of the water heater, respecting the local regulations . Operate regularly the discharge of safety device to prevent scaling and check that it is not blocked. -
Page 6: Electric Connection
All electrical work must be carried out by a registered electrician and in accordance with AS/NZ 3000. The Atlantic ESWH must be filled with water before connection to a power supply. Switch off the power before removing the cover to avoid any risk of injury or electric shock. -
Page 7: Thermal Cut-Out
Thermal cut-out All Atlantic ESWH are equipped with a thermal cut-out with manual resetting which shuts off the power to the water heater if it becomes overheated. If the circuit breaker keeps tripping, a) Switch off the power before taking any further action,... -
Page 8: Domestic Maintenance
Flushing of sediment and draining To flush or to drain the water heater, power must be turned off and then turn off the cold water supply to the water heater. The lever on the pressure and temperature relief valve should be opened but care should be taken so the lever does not snap back as it could damage the valve seat. -
Page 9: Installation
It is not unusual for the Pressure Temperature Relief valve to allow a small quantity of water to escape during the heating cycle and this must be left open to the atmosphere. Installation In accordance with AS/NZS 60335.2.21 the water heaters must be fixed to the ground using the attachment provided and in compliance with the New Zealand Building Code Clause G12, Seismic restraint of storage water heaters. -
Page 10: User Maintenance
requirement of AS 3500.4 & NZBC G12 that both a Stop Valve and a Non Return Valve are installed upstream of the Product. No parts (stop valve, pressure reducer, etc.) must be placed between the pressure limiting valve and the cold water inlet of the water heater, apart from a copper pipe. -
Page 11: Draining The Tank
Maintenance by a qualified person Remove the scale sludge. Do not scrape or chip at lime scale deposited on the casing because this may damage the lining Change the magnesium anode every 2 years or when its diameter is less than 10 mm. -
Page 12: Warranty Conditions
NZS 3500 Plumbing & Drainage Code; and NZ G12 New Zealand Building Code – must be complied with by the Installer. The Atlantic ESWH requires a single phase 16 amp supply requiring a licensed electrician for connecting. A licensed plumber must connect cold water and hot water supplies in accordance with this manual. -
Page 13: Warranty Exclusions
• Use of spare parts not recommended by manufacturer. Warranty Exclusions The following warranty exclusions may cause the Atlantic ESWH warranty to become void. This may also incur a service charge and cost for parts should they be necessary. ... - Page 14 (inside), roofs or other losses, directly or indirectly due to leakage from the Atlantic ESWH. Where the Atlantic ESWH has been powered up before it has been filled (heating when dry). Where the Atlantic ESWH has suffered external corrosion due to non-watertight piping connections.
-
Page 15: Warranty
of these waters due to groundwater salinity and aggressive mineralisation. Water MUST be from a supplied, reticulated source or from rainwater to ensure Warranty compliance. Warranty Water Heater Tank – Domestic 7 years Water Heater Tank – Commercial 3 years Warranty conditions apply: Tank labour –... - Page 16 FOR INFORMATION, REPAIRS AND SERVICE NEW ZEALAND: 0800 422 000 For Warranty Registration Register Online: www.atlantic.nz email: info@atlantic.nz...