Valor 719BPB Installation Instructions

719BPB 4-Sided Backing Plate
Use with 716EH and 721ED Edgemont Trim and Door fi tted to Valor 700 Models only
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.
The 719 4-Sided Backing Plate is intended to be used
with the 716 Edgemont Hammerered Trim Kits or the
721 Edgemont Door Kits to install on the Valor heater
model 700.
!
Please note the appliance will have to be raised
by 2-5/8" when using the 719BPB 4-Sided
Backing Plate as the plate extends below the
bottom of appliance.
36-5/16" (922 mm)
719BPB with
721 Edgemont Door
4005865-02
© Copyright Miles Industries Ltd., 2016
L
EGEND
Installation Instructions
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
1-1/2"
(38 mm)
1/2"
(13 mm)
!
2-5/8" (67 mm)
between bottom of backing
plate and bottom of appliance
G3.5
Leave this manual
with the appliance.
Retain this manual
for future reference.
Mounting of the 719 does not aff ect clearances or other
specifi cations listed in the heater installation manuals—
see installation manual supplied with the heater for
more information.
719BPB Backing Plate
Edgemont Door and side doors
Overview—shown with 721ED Edgemont Door
(engine, Edgemont Door Kit sold separately)
IN STA LLER
CO N SUM ER
700 engine