Mitsubishi PAJERO IV Service Manual page 46

2-22
Fuel high-pressure
tube
Fuel tank pump module
assembly connector
4. Disconnect the fuel tank pump module assembly
connector, fuel tank suction hose, fuel
high-pressure tube.
5. Remove the mounting nuts and retainer plate, and
remove the fuel pump module assembly from the
service hole.
FUEL PUMP
MODULE
Fuel tank filter
assembly
Packing
6. Replace the fuel tank filter assembly and packing
with a new one.
7. Install the fuel tank pump module assembly to the
fuel tank through the service hole.
8. Install the retainer plate to the fuel tank and
tighten the mounting nuts.
9. Connect the fuel tank pump module assembly
connector, fuel tank suction hose, fuel
high-pressure tube.
Fuel tank pump
module assembly
3 mm
PERIODIC INSPECTION AND MAINTENANCE
OPERATIONS INSIDE THE ENGINE COMPARTMENT
Fuel tank suction
hose
AC703272 AB
Fuel tank
pump
assembly
AC703246 AB
Fuel high-pressure tube
Quick connector
AC703276
AB
CAUTION
After connecting the fuel high-pressure tube,
slightly pull it to ensure that it is installed
securely. Also confirm that there is a play
approximately 3 mm.
10.Install the service hole cover (lower side).
11.Install the service hole cover (upper side).
12.Restore the second seat (R.H.).
<4M4>
1. Remove the fuel tank cap to release the pressure
inside the fuel tank.
<4M40>
<4M41>
Fuel filter
assembly
2. Disconnect the connector and the fuel hose, and
then remove the fuel filter assembly from the
bracket.
3. Remove the water level sensor.
4. Use an oil filter wrench to remove the fuel filter
cartridge from the fuel filter pump body.
Fuel filter assembly
AC610457AB
AC608826 AB
AC609422