Mitsubishi PAJERO IV Service Manual page 37

NOTE: Size identification mark: "2775" = 2.775
mm thickness
(3) Remove the camshaft and install the shim
which was selected in step (2).
(4) Re-measure the valve clearances and check
that they are all at the standard value.
5. Turn the crankshaft once to align the notch of the
crankshaft pulley with the timing mark "0".
6. Check and adjust the other valve clearances
according to the step 4.
VALVE CLEARANCE CHECK AND
ADJUSTMENT <4M41>
NOTE: The valve clearance check and adjustment
should be done when the engine is cold.
1. Remove the EGR pipe.
CAUTION
Leaked fuel on parts causes a decrease in func-
tion and burning. Therefore, place waste to
absorb leaked fuel.
MB992188
MB992188
PERIODIC INSPECTION AND MAINTENANCE
OPERATIONS INSIDE THE ENGINE COMPARTMENT
Identification
size mark
AK603848AB
AC609910 AB
AK600672
AB
2. Use the special tool fuel injection pipe wrench
(MB992188) to remove the fuel injection pipe.
3. Remove the rocker cover.
CAUTION
The crankshaft should always be turned in a
clockwise direction.
Timing marks
Camshaft sprocket
Crankshaft pulley
4. Align the camshaft sprocket timing marks and set
the No. 1 cylinder at top dead centre.
Exhaust valve side
Intake valve side
5. Measure the valve clearance.
If the valve clearance is not as specified, loosen
the rocker arm lock nut and adjust the clearance
using a thickness gauge between the camshaft
and the roller while turning the adjusting screw.
Standard value (cold engine):
Intake valve: 0.10 mm
Exhaust valve: 0.15 mm
2-13
Timing marks
AC610704AB
AK500544AB