Table of Contents
Advertisement
1-10
2. If the fluid is added, start the engine and turn the
steering wheel from stop to stop several times to
expel air from the system.
Specified gear oil: Automatic transmission
fluid DEXRON III or DEXRON II
12. ELECTRICAL WIRING
13. TYRE AND SPARE TYRE PRESSURES
1. Tyre specification
Check the correct tyre specification.
2. Tyre pressures
Adjust each tyre pressure.
NOTE: Recommended pressure is shown on the
tyre pressure label.
3. Valve stem extensions
Verify that the valve stem extensions are installed
where necessary.
4. Install the wheel covers, wheel rings and hub
caps.
PRE-DELIVERY INSPECTION
UNDER VEHICLE
1. Each electrical wiring harness and connector
2. Ignition cable
M6010500700024
AC305617
UNDER VEHICLE
14. SUSPENSION SYSTEM
M6010600100041
AC305618
Check to be sure that each installation bolt and nut is
tightened. If split pins are used, make sure that they
are properly installed.
1. Lower arm, Upper arm
2. Stabilizer bar
3. Strut assembly
(1) Check each harness to be correctly routed
and securely clipped.
(2) Confirm that all connections are tight.
Be sure that all ignition cables are firmly attached
to the spark plugs, distributor cap (or crank angle
sensor) and ignition coil.
M6010600200082
AC305609
Advertisement
Chapters
Table of Contents
