Sharp CE-150 Service Manual page 15

All and more about Sharp PC-1500 at http://www.PC-1500.info
Reassembly Parts S.ymbol
Sequence
12
Parts to be Reassembled Precautions for Reassembly
The wire must be stretched in the
order described below :
I)
As shown in Fig.
I ,
the spring
must be pressed against the side
plate using
a
ftnger tip with the
knot of the wire in alignment
with the side plate at point (A).
2) Next, thread the leading edge of
the wire through the puUey
(B)
and the protrusion (C).
3) As shown in Fig. 2. align the
slit (D)
of
the bobbin
gear so
that ii should on a line drawn
between the bobbin gear shaft
(E) and
the idler gear shaft (F).
®
@
Fig.
2
4) Wind the wire around the
bobbin gear for one and half
a
tum , then thread ii through
slits.
Fig. 3
Do not sale this PDF !!!