Table of Contents
Advertisement
Set Up Wireless Ad-Hoc
MP Compact4 Mark III User Guide
After a successful setup is made via a wired connection, the wireless
connection (if equipped) can now be configured in ad-hoc mode using a static
IP address. To configure the wireless card in ad-hoc mode, you must configure
your host computer to match the IP settings of the printer. Refer to your
operating system's or your wireless network card's documentation for
information on how to configure your computer.
1 Open your web browser.
2 Type in the IP address of the printer. The default IP is: 192.168.10.26.
Note: If a different IP address has been assigned to the printer, make sure to
enter the correct IP address.
3 Click on Wireless Ethernet Settings on the left side of the screen. Locate
and set the following items:
•
In the Acquire Address Method section, select the Use Static
Addresses radio button.
•
In the Static IP Addresses section, enter valid static IP addresses for
Printer IP Address, Printer Subnet Mask, and Printer Gateway.
4 Scroll down the page to Network Type, select Ad-hoc from the drop-down
menu.
5 In the SSID field, type the name of the SSID you wish to assign to the
printer.
6 Under the WiFi Security and Authentication, set any security/authentication
settings necessary for your network.
7 Scroll down to the bottom of the page, enter the password (default is
"sysadm") and click Apply.
8 Click on General Network Settings on the left side of the screen. Locate
and set the following items:
•
In the Network Interface, select the Wireless Ethernet radio button.
9 Scroll down to the bottom of the page, enter the password (default is
"sysadm") and click Apply.
Appendix B — Wireless and Wired LAN
47
Hide quick links:
Advertisement
Table of Contents
