Table of Contents
Advertisement
Chapter 5 — Printer Maintenance
Download Firmware
34
The operating firmware for the printer is stored in flash memory on the printer's
main PCB. When firmware is updated and/or new features are added, they can
be downloaded to the printer as follows.
1 Identify the new version for your printer model from our website at
www.honeywellaidc.com
2 Be sure the Windows driver is installed (see
on page
22) and the printer is connected to the host via a USB or LAN
(wired or wireless) connection.
Note: The Printer NETira Configuration Utility, (NETira CT) may also be used to
send this file to the printer.
3 Open the Properties dialogue box for the printer to be updated.
4 Click on the Tools tab.
5 Click on the Action drop-down box and select Send File to Printer.
6 Change the Files of type: drop-down box to All Files (*.*).
7 Navigate to the location of the firmware file downloaded in step 1, (.zg file)
and click Open.
8 As the new firmware is sent to the printer, the status light will flash as the
data is received.
9 Following a successful download, the printer will perform a cold reset.
The previous printer setup will not be affected unless substantial firmware
data structure changes have occurred. Print a database configuration label
to verify your new firmware version.
Following an unsuccessful download, the printer will perform a warm
reset. The original firmware will remain operational. If the printer fails to
reset, toggle the power off and on. Try resending the file to the printer.
If the failure continues, check the following possible causes.
•
An invalid or corrupted file is being downloaded — Ensure the file
being downloaded is correct and applicable for your printer model.
and download it onto your computer's hard drive.
"Install the Windows Driver"
MP Compact4 Mark III User Guide
Hide quick links:
Advertisement
Table of Contents
