Table of Contents
Advertisement
3A. Attach a Front Post (B) to one of the Rear Posts (C) by using:
2 - (8) Hex Bolt M12x1.75x100L
2 - (52) Washer D24x D13.5x2.5
2 - (66) Washer D37xD13x3.0
2 - (76) Nylon Nut M12
Note: Make sure the smaller holes that run up the sides of the Front
Post (B) are positioned in the forward position, as in the diagram on the
next page.
3B. Attach the bottom portion of the Front Post (B) (from step 3A) and one
Flat Mounting Plate (K) to the Foot Bar (A) by using:
2 - (16) Hex Bolt M12x1.75x105L
4 - (52) Washer D24x D13.5x2.5
2 - (76) Nylon Nut M12
3C. Repeat steps 3A and 3B for the second Front Post (B).
Make sure all the foot plates are flat on the ground and proceed to thoroughly
tighten the hardware from steps 1, 2 and 3.
STEP 3
14
Advertisement
Table of Contents
