AT&T activeARC ARC1000MAP Configuration Manual page 41

USA – Federal Communications Commission (FCC) EMC compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet prepared by the Federal Communications Commission helpful: The Interference Handbook.
This booklet is available from the US Government Printing Office, Washington, DC 20402. Stock No. 004-000-0034504.
ICC is not responsible for any radio or television interference caused by unauthorized modification of the devices included with this
ICC Wireless 11b/g PoE Access Point, Model activeARC
than specified by ICC.
The correction of interference caused by such unauthorized modification, substitution, or attachment will be the responsibility of the
user.
Changes or modifications not expressly approved by ICC could void the user's authority to operate this equipment.
Manufacturer's FCC declaration of conformity
Model Number: ARC1000MAP International Communications Corporation Equipment Type: WLAN Access Point
Complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
, or the substitution or attachment of connecting cables and equipment other
®
ARC1000MAP User's Manual
37