Fit/Fat Mode - AT&T activeARC ARC1000MAP Configuration Manual

system is left unattended for more than 5 minutes, the user will be logged out. The user will be required to log back into the web
management interface to continue configuring the access point.
If the first screen you see is one with a limited blue navigation side bar as in Figure 1.4 below, then your access
Note
point is in FIT (controller managed) mode. To operate the access point in FAT (stand-alone) mode, ensure
your AP mode is set to FAT mode. The default mode is FIT.

FIT/FAT mode

FIT mode is designed to operate with an AT&T activeARC
To change from FIT (controller managed) to FAT (stand-alone) follow these three simple steps:
1. Select AP Mode from the navigation bar.
2. Select Mode FAT.
Access Controller (AC).
®
Figure 1.4: Web management interface in FIT mode
ARC1000MAP User's Manual
7