Interior Components - Viking VUWC244DRSS Service Manual

1.4

Interior Components

1.4.1 Wine Shelves
A total of six (6) glide out shelves with wine mats.
Includes five (5) wine shelves
Overall shelf dimensions are: 19 ¼" wide x 17" deep
Shelf capacity of 8 bottles each
Extends outward: 12" maximum
Includes one (1) Bottom wine shelf
Overall shelf dimensions are: 19 ¼" wide x 11" deep
Shelf capacity of 4 bottles
Extends outward: 6 ½" maximum
1.4.1.1 To Remove Shelves
1) Unload shelf
2) Pull forward until the shelf has reached its forward limit.
3) Pick front edge of shelf upward towards a 45˚ angle.
4) Pull shelf out away from slides
5) Reverse process to install
NOTE: Built in units must accommodate a 90˚ door opening to facilitate shelf extension.
CAUTION
1) Do not lean or press down heavily on the wine shelves. Doing so may damage the shelves.
2) It is also advisable not to pull more then one wine shelf out at a time.
3) Pull wine shelves out carefully to minimize unsettling of the wine collection.
1.4.2 Lights
Each compartment has a 115 volt interior light. The lights function utilizing a door magnet mounted on
the inside of the cabinet door. A reed switch located inside the User Interface control turns the lights on
and off with each door position.
The lights can also be operated using "Display Lighting" or "Show Room Lighting". These functions are
controlled by the light keypad on the User Interface panel. Refer to Section 2, Paragraphs, 2.1.7 & 2.1.8
of this manual describing their use.
The interior lights come as an assembly piece which includes the bulb, mounting bracket, and electrical
plug.
1.4.2.1 To Replace the Light Assembly
1) Remove the top two shelves of the compartment to access the light assembly.
2) Disconnect the lights electrical plug where it plugs into the cabinet liner.
3) Remove the two hex head screws that fasten the fixture in place.
4) Remove and replace with new assembly.
2010 - Viking Preferred Service
4
SMR-0005